Service Manual

COMPONENT ACCESS
18” & 24” ADA Built-In Dishwashers
n
4-19
Removing the Sump Assembly (continued)
7. Remove the three (3) screws that aach the sump to the
tub. See Figure 2.
Remove 3 Screws
Figure 2
8. Remove the sump gasket (not shown) and sump.
9. Remove dishwasher from installaon and lay dishwasher
on its back.
10. Disconnect the thermistor wire harness and turbidity
sensor wire harness. See Figure 3.
Disconnect Harnesses
Figure 3
11. Remove the 2 clamps, sump outlet hose, and inlet hose
from the sump. See Figure 4.
Inlet Hose
Outlet Hose
Figure 4
NOTE: Factory installed hose clamps are not reusable.
When installing a water inlet valve, drain pump assembly,
wash pump assembly, or sump assembly, replace the old
clamps with new screw-type hose clamps provided. The
screw-type hose clamps are available separately.
12. Remove the drain pump from the sump.
13. Remove the inner drain hose from the sump.
Sump - Top View
Figure 5
Sump - Boom View
Outlet
Inlet
Turbidity
Sensor
Thermistor
Drain Pump
Drain Hose
Figure 6