Installation Instructions

11
REMOVE BENT ACCESS PANEL
Using a Phillips screwdriver, remove the two screws attaching
bent access panel to dishwasher.
9. Measure cabinet opening
Measure the height of cabinet opening from the underside of
the countertop to the oor where dishwasher will be installed.
Be sure to measure the lowest point on the underside of the
countertop and the highest point on the oor.
10. Leveling leg adjustment
Extend leveling legs out from the dishwasher base, 1/4"
(6.3 mm) less than the shortest opening height measured in
cabinet opening.
Turn leg counter clockwise to raise the dishwasher or clockwise
to lower the dishwasher.
CONNECT ELBOW TO VALVE
11. Connect elbow to ll valve
Elbow
Apply thread seal tape to 90°elbow tting and connect tting
to ll valve.
Tighten elbow until snug, and be sure that it faces toward
channel in bottom of base.
12. Fill valve location
Fill valve location
8. Remove bent access panel
Bent access
panel