Installation Instructions

19
1
1. Using a hammer and screwdriver, knock
plug into disposer.
2
2. Use needle-nose pliers to remove plug.
3
3. Attach drain hose to disposer inlet with
large 1" (2.5 cm) to 1½" (3.8 cm) drain
hose clamp (not provided).
Option B: No Waste disposer—no air gap
Waste tee
Large drain
hose clamp
Drain hose
Drain trap
1
Rubber
end
1. Fit rubber end of drain hose
towastetee.
2
2. Attach rubber end of drain hose to
waste tee with a hose clamp. Use a 1"
to 1
1
/
2
" (2.5 to 3.8cm) screw-type clamp
(not provided).
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock
plug into disposer.
2. Use needle-nose pliers to remove plug.
3. Connect rubber end of drain hose
toairgap.
4
4. Attach rubber end of drain hose to air
gap with a hose clamp. Use a1" to 1
1
/
2
"
(2.5 to 3.8 cm) screw-type clamp
(not provided).
5
5. Use a rubber hose (not provided) with
screw-type clamps to connect from air
gap to disposer inlet.
Option C: Waste disposer – with air gap
Large drain
hose clamp
Drain hose
Screw-type clamps
Air gap
Rubber hose
connector
Drain trap
Disposer inlet
1
2
Rubber
end
3