Installation Instructions

20
1. Connect rubber end of drain hose
toairgap.
2. Attach drain hose to air gap. Use a
1" to 1
1
/
2
" (2.5 to 3.8 cm) screw-type
clamp.
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Option D: No waste disposer –
withairgap
Large drain
hose clamp
Drain hose
Screw-type clamps
Air gap
Rubber hose
connector
Drain trap
Waste tee
1
Rubber
end
2
3
COMPLETE INSTALLATION
Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
48. Power supply cord—Plug into
a grounded 3 prong outlet
Plug into a grounded 3 prong outlet.
49. Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
NOTE: With the access panel off, start the dishwasher and allow
it to complete the shortest wash cycle. After the rst 2 minutes,
unlatch door, wait 5 seconds, then open door. Check that there is
water in the bottom of the dishwasher tub. Check that dishwasher
is working properly.
REINSTALL ACCESS PANEL
50. Reinstall bent access panel
Place the bent access panel against dishwasher legs.
51. Install at access panel in front of
bent panel
Place the at panel in front of the bent panel. Using a Phillips
screwdriver install the screws through the holes in the access
panel.
Bent access
panel