Owners Manual
17
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.
Electrical Shock Hazard
Plug into a grounded 4 prong outlet.
Failure to do so can result in death or
electrical shock.
VACATION, STORAGE, AND MOVING CARE (cont.)
For washers/dryers:
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. If washer/dryer will be moved during freezing weather,
follow “Winter Storage Care” directions before moving.
3. Disconnect drain hose from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4. Place inlet hoses and drain hose inside washer basket.
5. Drape power cord over edge and into washer basket.
6. Place packing tray from original shipping materials back
inside washer/dryer. If you do not have packing tray,
place heavy blankets or towels into basket opening.
Close lids/doors and place tape over lids/doors and
down front of washer/dryer. Keep lids/doors taped until
washer/dryer is placed in new location.
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer/
dryer where it will not freeze. Because some water may
stay in hoses, freezing can damage washer/dryer. If
storing or moving during freezing weather, winterize your
washer/dryer.
To winterize washer/dryer:
1. Shut off both water faucets, disconnect and drain
water
inlet hoses.
2. Put 1 quart (1 L) of R.V.-type antifreeze in basket and run
washer on Normal cycle for about 2 minutes to mix
antifreeze and remaining water.
3. Unplug washer/dryer or disconnect power.
REINSTALLING/USING WASHER/DRYER AGAIN
To reinstall washer/dryer after non-use, vacation, mo-
ving, or winter storage:
1.
Refer to Installation Instructions to locate, level, and
connect washer/dryer.
2. Before using again, run washer/dryer through the
following recommended procedure:
To use washer/dryer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
In the U.S.A.
In Canada
In the U.S.A. and Canada
1. Plug in washer/dryer or reconnect power.
2.
Run washer through Heavy Duty cycle to clean washer
and remove antifreeze, if used. Use only HE High Efciency
detergent. Use half the manufacturer’s recommended
amount of detergent for a medium-size load.