Owners Manual

6
CONTROL PANELS AND FEATURES
WASHER
1
2 3
5
4 6
4
7
LED TIME/STATUS DISPLAY
The Remaining Time display shows the time required for
the cycle to complete. Factors such as load size and water
pressure may affect the time shown in the display. Tightly
packed loads, unbalanced loads, excessive suds, or
adding or removing items may cause the washer to adjust
the cycle time as well.
LID LOCK LIGHT
The Lid Lock indicator lights up when the lid is locked and
cannot be opened. If you need to open the lid, press and
hold START/PAUSE. The lid will unlock 1 minute after the
washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Press the
START/PAUSE button again to restart the cycle.
START/PAUSE
After selecting a wash cycle, press START/PAUSE to start
the cycle. Press once to pause a cycle. The ashing lights
indicate the selected cycle and the current process.
CYCLE TIME (+ or -)
■ Press “+” or “-” to adjust the duration of a cycle.
■ LED display will show the time remaining for the cycle
to complete.
■ If an out-of-range adjustment is made, a buzzer will
sound.
End-of-Cycle Signal
Press and hold the plus (+) button for 3 seconds to
enable or disable the end-of-cycle signal.
Press and hold the minus (-) button for 3 seconds to
mute the signal.
CYCLES
Press CYCLES to select a wash cycle.
Choose from Normal, Delicate, Heavy Duty,
Rinse, Spin, or Clean Washer.
TEMP
Select a wash temperature based on the
type of fabric and soils being washed. For
best results and following the garment label
instructions, use the warmest wash water
safe for your fabric.
POWER ON/OFF
Press POWER ON/OFF to turn on or off the
washer. Press once while a cycle is running to
stop the washer.
CONTROL LOCK
Press and hold TEMP for 3 seconds to lock
the controls. Press and hold for 3 seconds to
unlock. You may still press POWER ON/OFF to
turn off the washer.