Installation Instructions

19

To Convert Gas Pressure Regulator (Propane Gas to
Natural Gas)
1. Remove storage drawer, warming drawer, or premium
storage drawer. See the “Storage Drawer” or “Warming
Drawer or Premium Storage Drawer” section.
2. Locate gas pressure regulator at rear of storage drawer,
warming drawer or premium storage drawer compartment.
NOTE: On models with a warming drawer, an access cover
must be removed to access the gas pressure regulator.
IMPORTANT: Do not remove the gas pressure regulator.
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the solid end faces out and the marking
“ NG” is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Propane Gas to Natural
Gas)
1. Remove burner cap.
2. Remove the burner base.
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orice spud in the nut driver while changing
it. Press nut driver down onto the gas orice spud and remove
by turning it counterclockwise and lifting out. Set gas orice
spud aside.
4. Gas orice spuds are stamped with a number on the side or
top. Replace the propane gas orice spud with the correct
Natural gas orice spud.
A
A. Gas pressure regulator
A
B
C
D
Side view before
Side view after
E
NG
LP
LP
NG
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing
out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter electrode
E. Gas tube opening
D
E
C
B
A
A
B
C
D
A. Igniter electrode
B. Orice spud
C. Orice spud holder
D. Screws
A. Stamped number
XXX
XXX
A