Installation Instructions

20
Refer to the following chart for the correct Natural gas orice
spud placement.
Natural Gas Orice Spud Chart
Burner Rating Size (mm) ID Number
18,000 BTU 2.00 200AM
17,000 BTU 1.96 196AM
15,000 BTU 1.80 180AM
9,500 BTU 1.40 140AM
8,000 BTU 1.30 130AM
5,000 BTU 1.00 100AM
NOTE: Refer to the model/serial/rating plate located on the oven
frame behind the top right-hand side of the oven door for proper
sizing of spuds for each burner location.
5. Place propane gas orice spuds in the orice spud bag.
IMPORTANT: Keep the propane gas orice spuds in case
of reinstallation with propane gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 to 7 for the remaining burners.
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1. Remove the oven racks.
2. Remove 2 screws at the rear of the oven bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
4. Remove 2 screws from the front tabs of the ame spreader.
Lift front of the ame spreader and pull forward to remove
tabs from rear of oven and set it aside on a covered surface.
5. Remove 2 screws from the bake burner.
6. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orice, and set the bake burner aside.
7. Use a 3/8" (1 cm) nut driver or combination wrench and turn
the Propane gas bake burner orice spud counterclockwise
to remove. The spud will be stamped with a “57.”
8. Replace the “57” spud with a “51” spud. Install the Natural
gas bake burner orice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
9. Position the back of the bake burner over the oven orice,
and slide the tab on front of the bake burner into the front of
the oven.
10. Reattach the bake burner with 2 screws.
11. Insert the tabs on the rear of the ame spreader into the rear
of the oven.
12. Reattach the front tabs of the ame spreader to the oven
with 2 screws.
13. Position the front of the oven bottom panel toward the front
frame and lower the rear of the oven bottom panel into the
oven.
14. Reattach the oven bottom panel with 2 screws.
A
B
A. Screws
B. Oven bottom
A
B
A. Screws
B. Flame spreader
A
B
A. Screws
B. Bake burner
A
A. Orice spud