Service Manual
Table Of Contents
- Whirlpool & Maytag 27" Front-Load Gas & Electric Dryers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Component Testing
- Testing - Safety Information
- Component Locations - Whirlpool
- Wiring Diagram - Whirlpool Electric
- Wiring Diagram - Whirlpool Gas
- Wiring Diagram - Maytag Electric
- Wiring Diagram - Maytag Gas
- Component Testing
- TEST #1: ACU Power Check
- TEST #2: Supply Connections
- TEST #3: Motor Circuit
- TEST #4: Heat System
- TEST #4a: Thermistors
- TEST #4b: Thermal Fuse
- TEST #4c: Thermal Cut-Off
- TEST #4d: Gas Valve (Gas Dryer)
- TEST #5: Moisture Sensor
- TEST #6: Buttons & Indicators
- TEST #7: Door Switch
- TEST #8: Drum LED
- TEST #9: Water Valve
- Section 4: Component Access
- Component Locations - Whirlpool
- Door Reversal - Round Shaped Doors
- Door Reversal - Square Shaped Doors
- Removing the Top Panel & Console/HMI
- Removing the Appliance Control Unit (ACU)
- Removing the Front Panel & Door Switch
- Removing the Drum Light & Moisture Sensor
- Removing the Belt, Drum, and Rollers
- Removing the Drive Motor
- Removing the Thermal Fuse & Outlet Thermistor
- Removing the Heater, High Limit Thermostat & Thermal Cutoff
- Removing the Ignitor, Flame Sensor, High-Limit Thermostat and Thermal Cutoff (Gas Models)
- Removing the Gas Burner Assembly Coils (Gas Models)
- Removing the Rear Panel
- Removing the Water Valve
- Section 5: Connectivity
- Product Specifications & Warranty Info
COMPONENT TESTING
Whirlpool & Maytag Front-Load Dryers
n
3-1
Section 3:
Component Testing
This secon provides a wiring diagram, control board
specicaons, tesng procedures and strip circuits for the
“Whirlpool & Maytag Front-Load Gas & Electric Dryers.”
n Tesng: Safety Informaon
n Component Locaons
n Wiring Diagram - Whirlpool, Electric
n Wiring Diagram - Whirlpool, Gas
n Wiring Diagram - Maytag, Electric
n Wiring Diagram - Maytag, Gas
n Component Tesng
n TEST #1: ACU Power Check
n TEST #2: Supply Connecons
n TEST #3: Motor Circuit
n TEST #4: Heang System
n TEST #4a: Thermistors
n TEST #4b: Thermal Fuse
n TEST #4c: Thermal Cut-O
n TEST #4d: Gas Valve (Gas Dryer)
n TEST #5: Moisture Sensor
n TEST #6: Buons and Indicators
n TEST #7: Door Switch
n TEST #8: Drum LED
n TEST #9: Water Valve