Service Manual

COMPONENT ACCESS
Whirlpool & Maytag Front-Load Dryers
n
4-19
Removing the Ignitor, Flame Sensor, High-Limit Thermostat
and Thermal Cutoff (continued)
6. To remove the Flame Sensor (see Figure 4):
a) Disconnect the two (2) wire connectors from the ame
sensor terminals.
b) Remove the ame sensor screw from the burner
venturi and remove the sensor.
Venturi
Flame Sensor
Wire Connectors
Screw
Figure 4 - Removing Flame Sensor
7. To remove the High-Limit Thermostat or the Thermal
Cuto (see Figure 5):
a) Disconnect the two (2) wire connectors from the
component terminals.
b) Remove the two (2) screws from the High-Limit
Thermostat, or the single screw from the Thermal
Cuto. Remove the component from the venturi.
Thermal Cuto
(1 Screw)
High-Limit Thermostat (2 Screws)
Figure 5 - Gas Burner Thermals