Service Manual

4-20
n
Whirlpool & Maytag Front-Load Dryers
COMPONENT ACCESS
Removing the Gas Burner Assembly Coils (Gas Models Only)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Gas Burner Assembly Coils
1. Unplug dryer or disconnect power.
2. Turn o gas supply to dryer.
3. Perform the procedures on page 4-9, “Removing the Top
Panel and Console/HMI” prior to performing the following
steps.
4. Perform the procedures on page 4-11, “Removing the
Front Panel” prior to performing the following steps.
Figure 1 - Gas Burner Assembly
5. Remove the ignitor from the burner (see page 4-18 for the
procedure).
6. Disconnect the 2-wire and 3-wire connectors from the
burner coil assembly terminals (see Figure 3).
7. Remove the two screws from the burner support bracket
and remove the bracket from the burner (see Figure 3).
8. Remove the two screws from the front of the burner
bracket and remove the burner assembly from the dryer.
Figure 2
Coils w/
Connectors
Burner Bracket
Screws
2-Wire
Support Bracket
Screws
3-Wire
Support
Bracket
Figure 3 - Burner Screws and Connectors
9. Remove the one (1) Phillip screw, indicated in Figure 4, to
release the coil pack.
Coil Pack
Retainer Screw
Figure 4 - Remove retainer screw.
10. Li and remove the coil pack from the valve assembly. See
Figure 5.
LIFT
Figure 5 - Lift and remove coil pack.
Figure 2 - Gas Burner Assembly