Use and Care Guide

Continuous Mode and Drain Hose

Connection (optional)

The Continuous mode allows the unit to run continuously

(depending on the selected humidity level) without having to

empty the water bucket.

To drain continuously, attach a hose (not included) for water

drainage into a oor drain.

The drain tting uses a standard garden hose connector.

The drain hose must be below the drain port on the back

of the dehumidier to ensure proper drainage.

NOTE: Use GHT or “garden hose thread”, which has an outer

diameter of 1

/16" (27 mm) and a pitch of 11.5 TPI (threads per

inch).

1. Remove drain tting plug

Place the dehumidier on a level surface. Unscrew the cap on the

back of the unit to access the drain tting.

2. Install drain hose

Thread the drain hose (not included) onto the drain tting on the

dehumidier. Lead the rest of the hose to a oor drain and cut to

length (no longer than 6’ long). Make sure that there are no kinks

or knots in the garden hose. Turn on the unit and press the Mode

button until set to Continuous mode.