Installation Guide

2
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Parts Supplied (not shown to scale)
For information on reordering, see “Replacement Parts” section.
*Depending on cabinet shelf depth and/or cabinet trim overhang
length, bolts longer than those provided (40 mm) may be
required.
Location Requirements
NOTE: This microwave oven is intended for installation over a
countertop. Do not install this microwave oven over any heat
source, such as a range or cooktop.
Check the opening where the microwave oven will be installed.
The location must provide:
■ Minimum cabinet depth of 12" (30.5 cm).
■ Minimum cabinet lower shelf thickness of 3/16" (5 mm).
■ Support for weight of at least 50 lbs (22.7 kg), in addition to
the normal contents of the cabinet, as well as any items that
might be hanging from the bottom of the cabinet.
■ Grounded electrical outlet inside upper cabinet. See
“Electrical Requirements” section.
■ To allow for adequate ventilation, which is important for
product performance, a clearance of at least 2¹⁄₂" (6.4 cm)
must exist between the microwave oven and a side wall (or
cabinetry wall) on each side.
Product Dimensions
■ Measuring tape
■ Pencil
■ Masking tape
■ Scissors
■ No. 2 Phillips screwdriver
■ Drill
■ 1/2" (13 mm) drill bit
■ 1/2" (13 mm) wood bit or
metal hole cutter (if
installing under a metal
cabinet)
■ Covering or microwave
oven carton
5 mm x 80, 40 mm bolts (4)* C-washers (4)
Spacers (8) Templates A and B
10
¹⁄₂
"
(26.7 cm)
12
¹⁄₂
"
(31.8 cm)
18
" (45.7 cm)