Instructions for use WASHING MACHINE Contents GB English,1 PT Português,13 GB Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 4 Cutting off the water and electricity supplies Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and advice, 5 General safety Disposal Opening the porthole
Installation GB ! Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured in relation to the worktop, must not exceed 2°. Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating.
Connecting the drain hose 65 - 100 cm Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor; alternatively, placed it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater. ! When the washing machine has been installed, the electricity socket must remain within easy reach. ! Do not use extension cords or multiple sockets.
Care and maintenance GB Cutting off the water and electricity supplies Caring for the door and drum of your appliance • Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the washing machine and help to prevent leaks. • Always leave the porthole door ajar in order to prevent unpleasant odours from forming. • Unplug the washing machine when cleaning it and during all maintenance work.
Precautions and tips ! This washing machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. General safety • This appliance was designed for domestic use only.
Description of the washing machine GB Control panel TEMPERATURE CHILD LOCK button button ON/OFF CLEANING ACTION button button DISPLAY Detergent dispenser drawer WASH CYCLE SELECTOR KNOB SPIN button OPTION button and indicator light START/PAUSE button and indicator light DELAY TIMER button Detergent dispenser drawer: used to dispense detergents and washing additives ( see “Detergents and laundry”).
Display GB The display is useful when programming the machine and provides a great deal of information. The duration of the available wash cycles and the remaining time of a running cycle appear; if the DELAY TIMER option has been set, the countdown to the start of the selected wash cycle will appear.
Running a wash cycle GB 1. SWITCH THE MACHINE ON. Press the button; the START/PAUSE indicator light will flash slowly in a green colour. 2. LOAD THE LAUNDRY. Open the porthole door. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes and wash cycles on the following page. 3. MEASURE OUT THE DETERGENT. Pull out the detergent dispenser drawer and pour the detergent into the relevant compartments as described in “Detergents and laundry”. 4.
Wash cycles and options Bleach Fabric softener Max. load (kg) Residual dampness% Energy consumptionkWh Total water lt Cycle duration 10 - 4 4 - - - 180’ 180’ (3) 6 53 1.03 49 190’ 6 53 1.09 92 180’ - 3.5 3.5 4 4 1.5 1 44 0.93 47 110’ 44 0.57 46 95’ - 195’ - 145’ - 70’ - 80’ - - 3.5 53 0.81 40 60’ 1000 - 6 1000 - - 6 53 0.11 60 80’ 800 - - 3 48 0.
Detergents and laundry GB Detergent dispenser drawer Successful washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. ! Use powder detergent for white cotton garments, for prewashing, and for washing at temperatures over 60°C. ! Follow the instructions given on the detergent packaging.
Troubleshooting Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service (see “ Service”), make sure that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The washing machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. GB • There is no power in the house. The wash cycle does not start.
Service GB Before contacting the Technical Assistance Service: • Check whether you can solve the problem alone (see “Troubleshooting”); • Restart the wash cycle to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Assistance Centre. ! Always request the assistance of authorised technicians. Have the following information to hand: • the type of problem; • the appliance model (Mod.); • the serial number (S/N).
Instruções para a utilização MÁQUINA DE LAVAR ROUPA Sumário PT Português PT Instalação, 14-15 Desembalar e nivelar Ligações hidráulicas e eléctricas Primeiro ciclo de lavagem Dados técnicos Manutenção e cuidados, 16 Interromper a alimentação de água e de corrente eléctrica Limpar a máquina de lavar roupa Limpar a gaveta dos detergentes Cuidados com a porta de vidro e o tambor Limpar a bomba Verificar o tubo de alimentação de água Precauções e conselhos, 17 WMF 601 Segurança geral Eliminação Abertura m
Instalação PT ! É importante guardar este livrete para poder consultá-lo a qualquer momento. Se a máquina for vendida, cedida ou transferida, certifique-se que este livrete permaneça com a máquina para informar o novo proprietário acerca do seu funcionamento e das respectivas advertências. Um cuidadoso nivelamento dá estabilidade à máquina e evita vibrações, ruídos e deslocamentos durante o funcionamento.
Ligação do tubo de descarga 65 - 100 cm Ligue o tubo de descarga, sem dobrálo, a uma conduta de descarga ou a uma descarga na parede situada entre 65 e 100 cm de altura do chão; ou coloque na beira de um lavabo ou de uma banheira, prenda na torneira a guia fornecida (veja a figura). A ponta solta do tubo de descarga não deve permanecer emergida na água.
Manutenção e cuidados PT Interromper a alimentação de água e de corrente eléctrica • Feche a torneira da água depois de cada lavagem. Desta maneira diminuiu-se o desgaste do sistema hidráulico da máquina de lavar roupa e elimina-se o risco de inundação. • Tire a ficha da tomada eléctrica quando for limpar a máquina de lavar roupa e durante os trabalhos de manutenção. Limpar a máquina de lavar roupa • A parte externa e as peças em borracha podem ser limpas com um pano molhado com água morna e sabão.
Precauções e conselhos ! Esta máquina de lavar roupa foi projectada e fabricada em conformidade com os regulamentos internacionais de segurança. Estas advertências são fornecidas por razões de segurança e devem ser lidas com atenção. Segurança geral • Este aparelho foi projectado exclusivamente para um uso doméstico.
Descrição da máquina de lavar roupa PT Painel de comandos Tecla BLOQUEIO DAS TECLAS Tecla da Tecla ON/OFF TEMPERATURA Tecla INTENSIDADE LAVAGEM Visor Tecla e indicador luminoso Selector de PROGRAMAS Gaveta dos detergentes START/PAUSE Tecla Teclase indicadores luminosos de CENTRIFUGAÇÃO Tecla OPÇÃO INÍCIO POSTERIOR Gaveta dos detergentes: para colocar detergentes e aditivos (veja “Detergentes e roupa”). Tecla ON/OFF : carregue brevemente na tecla para ligar ou desligar a máquina.
Visor PT O visor é útil para programar a máquina e fornece muitas informações. É visualizada a duração dos vários programas à disposição e, quando o ciclo tiver iniciado, é visualizado o tempo que falta para a sua conclusão; no caso em que tenha sido programado um INÍCIO POSTERIOR, será visualizado o tempo Restante para o início do programa seleccionado.
Como efectuar um ciclo de lavagem PT 1. LIGAR A MÁQUINA. Carregue na tecla ; o indicador luminoso START/PAUSE piscará lentamente na cor verde. 2. COLOCAR A ROUPA Abrir a porta de vidro. Coloque a roupa dentro da máquina prestando atenção para não superar a carga máxima indicada na tabela dos programas na página seguinte. 3. DOSAGEM DO DETERGENTE.Extrair a gaveta e deitar o detergente nos específicos recipientes como explicado no parágrafo “Detergentes e roupa”. 4. FECHAR A PORTA DE VIDRO. 5.
Programas e opções Tabela dos programas PT Lavagem Água de Javel Amaciador Carga max. (Kg) Humidade residual % Consumo de energia kWh Água total lt Duração ciclo 40° 60° 60° Programas de lavagem normal de algodão 60º (1): brancos e coloridos resistentes muito sujos. (Max. 90°) 1000 1000 - 4 4 - - - 180’ 180’ 1000 (3) 6 53 1.03 49 190’ Programas de lavagem normal de algodão 40º (2): brancos e coloridos delicados pouco sujos. 40° 1000 - 6 53 1.
Detergentes e roupa PT Gaveta dos detergentes O bom resultado da lavagem depende também do emprego da dose certa de detergente: com excessos não se lava de maneira mais eficaz, mas contribui-se para formar crostas nas peças internas da máquina de lavar roupa e poluir o meio ambiente. ! Usar detergentes em pó para roupas de algodão brancas e para a pré-lavagem e para lavagens com temperatura superior aos 60ºC. ! Seguir as indicações fornecidas pelo produtor na embalagem do detergente.
Anomalias e soluções Pode acontecer que a máquina de lavar roupa não funcione. Antes de telefonar para a Assistência Técnica (veja “Assistência”), verifique se não se trata de um problema fácil de resolver com ajuda da seguinte lista. Anomalias: PT Possíveis causas / Solução: A máquina de lavar roupa não liga. • A ficha não está colocada na tomada eléctrica, ou não o suficiente para haver contacto. • Em casa não há corrente. O ciclo de lavagem não inicia.
Assistência 195101626.00 04/2012 - Xerox Fabriano PT Antes de contactar a Assistência Técnica: • Verifique se consegue resolver a anomalia sozinho (veja “Anomalias e soluções”); • Reinicie o programa para verificar se o inconveniente foi resolvido; • Em caso negativo, contacte um Centro de Assistência Técnica. ! Nunca recorra a técnicos não autorizados. Comunique: • o tipo de anomalia; • o modelo da máquina (Mod.