Installation Instruction
9
5. The bottom vent and bottom vent trim (required when the
oven is installed with the feet in the tall position) are shipped
in the foam packing at the top of the oven.
To install only the bottom vent, see the following instructions.
To install both the bottom vent and the bottom vent trim
for installations with the feet in the tall position, see the
instructions in Step 6.
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (D) on each side
of the vent tab (B), fasten the vent securely to the oven.
6. On models with the feet installed in the tall position, the
bottom vent trim must also be installed. See the following
instructions to install.
■ Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the bottom vent trim (B) between them.
Some force may be required to flex the upper vent trim
(C) away from the lower vent trim (D). Some force may
also be required to flex the bottom vent trim (B) and
slide it into position. Make sure screw holes are properly
aligned between the two pieces. See the following
illustration.
■ Install the bottom vent trim (B) to the lower vent piece (D)
using two #8-18 x 1/4" (6.4 mm) screws on each side.
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of
the vent tab (B), fasten the vent securely to the oven.
7. Replace the oven racks.
8. Replace the oven door. See the “Replace Oven Door(s)”
section.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
“Prepare Built-In Oven” section.
10. Repeat for lower oven door.
11. Reconnect power.
12. The display panel will light briefly, and “PF” should appear in
the display.
13. If the display panel does not light, reference the “Warranty”
section of the Use and Care Guide.
Install Warming Drawer Deector Kit
(only for ovens installed above
warming drawers)
On combo microwave/oven models installed above a warming
drawer, a warming drawer deflector kit must be installed. See the
“Tools and Parts” section for information on ordering.
Parts Supplied
A. Oven frame
B. Vent tab
C. Oven vent
D. #8-18 x 3/8" (9.5 mm)
screws
A
C
D
B
A. #8-18 x 1/4" (6.4 mm)
screws
B. Bottom vent trim
C. Upper vent piece
D. Lower vent piece
D
B
A
C
D
C
B
A. Oven frame
B. Vent tab
C. Oven vent
D. Bottom vent trim
E. #8-18 x 3/8" (9.5 mm)
screw
A
C
D
B
E
A. Phillips head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deflector (1)
B
A