Owner's Manual

16
Cutout Height is Between 51
3
/
16
" and 52
3
/
16
" (130.0 cm and
132.6 cm)
NOTE: A tall bottom vent shield can be ordered to replace the
shield that came with the unit as an optional bottom aesthetic. The
oven will function properly with either shield. Please refer to your
Quick Start Guide for the service number to call and request at no
charge.
1. Using 2 or more people, place the oven on its back on a
covered surface.
2. Install a rear foot on the left rear spacer using a #8-18 x 3/8"
(9.5 mm) screw.
NOTE: Position the rear foot so the short side of the foot is
facing toward the top of the oven.
A. Spacer
B. Rear foot
C. #8-18 x 3/8" (9.5 mm) screw
3. In the same manner, install a rear foot on the right rear of the
oven.
4. Install a front foot on the left front using a #8-18 x 3/8"
(9.5 mm) screw.
NOTE: Position the foot so the short side of the foot is facing
toward the top of the oven.
A. Front Foot
B. #8-18 x 3/8" (9.5 mm) screw
C. Spacer
5. In the same manner, install a front foot on the right front of the
oven.
6. Using 2 or more people, place the oven in its upright position.
7. Go to the “Make Electrical Connection” section.