Owner's Manual

11
3. Starting with the right-hand side door, remove the parts for the
top hinge as shown below. Lift the refrigerator door from the
bottom hinge pin.
A. Hinge Cover Screw C. 5/16” Hex-Head Hinge Screws
B. Top Hinge Cover D. Top Hinge
4. Remove the hinge pin cover from the bottom hinge pin and
keep it for later use.
5. Before removing the left-hand side door, disconnect the wiring
plug located on top of the top hinge by wedging a flatblade
screwdriver or your fingernail between the two sections..
NOTE: The green, ground wire remains attached to the hinge.
6. Remove the parts for the left-hand side door top hinge as
shown in the Top Hinge graphic in Step 3. Lift the door from
the bottom hinge pin.
NOTE: Remove the hinge pin cover from the bottom hinge pin
and keep it for later use.
A. Hinge Pin Cover C. Hinge Screws
B. Bottom Hinge
Reverse Doors (optional)
IMPORTANT: If you want to reverse your door so it opens from
the opposite side, follow these steps. If you are not reversing the
door, see “Replace Door(s) and Hinges.”
Cabinet
1. Remove hinge screws from handle side and move them to
opposite side.
A. 5/16" Hex-Head Hinge Screws
Refrigerator door
1. Remove the refrigerator handle assembly. See “Remove and
Replace Door Handles.” Keep all parts together.
2. Remove door handle seal screw front. Move to opposite side
of refrigerator door as shown below.
3. Remove the door stop. Move it to the opposite side of the
refrigerator door as shown below.
A. Door Stop Screws B. Door Stop
4. Attach refrigerator handle on opposite side of the refrigerator
door with the two screws. Replace handle trim. See “Remove
and Replace Door Handles.”
5. Tighten all screws. Set aside the door until hinges and freezer
compartment drawer are in place.