Owner's Manual
Table Of Contents
- REFRIGERATOR SAFETY
- MAINTENANCE AND CARE
- Cleaning
- Changing the LED Module
- Water Filtration System
- Vacation and Moving Care
- INSTALLATION INSTRUCTIONS
- Unpack the Refrigerator
- Electrical Requirements
- Location Requirements
- Water Supply Requirements
- Connect the Water Supply
- REFRIGERATOR FEATURES
- Crisper Humidity Control
- DOOR AND HANDLE INSTRUCTIONS
- Refrigerator Doors and Drawer
- Remove and Replace Door Handles
- Remove Doors and Hinges
- Reverse Doors (optional)
- Replace Doors and Hinges
- Remove and Replace Freezer Drawer
- PERFORMANCE DATA SHEET
- Performance Data Sheet
- SÉCURITÉ DU RÉFRIGÉRATEUR
- Sécurité du réfrigérateur
- ENTRETIEN ET RÉPARATION
- Nettoyage
- Remplacer le module à DEL
- Système de filtration de l’eau
- Précautions à prendre avant les vacances ou le déménagement
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Spécifications électriques
- Exigences d’emplacement
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- CARACTÉRISTIQUES DU RÉFRIGÉRATEUR
- Réglage de l’humidité dans le tiroir à légumes
- INSTRUCTIONS POUR LA PORTE ET LA POIGNÉE
- Portes et tiroir du réfrigérateur
- Consulter la section Retrait et réinstallation des poignées de porte
- Démontage des portes et charnières
- Inversion des portes (facultatif)
- Réinstallation des portes et charnières
- Retrait et réinstallation du tiroir de congélation
- FICHE DE DONNÉES DE PERFORMANCE
- Fiche de données de performance
15
3. So the doors will close easier, use a 1/4" hex driver to turn
both leveling screws clockwise. This will raise the front of the
refrigerator tilting it slightly downward to the rear. Turn both
leveling screws the same amount.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws.
A. Leveling screw
4. Open and close the doors to make sure they close as easily
as you like. If not, increase the tilt by turning both leveling
screws clockwise. It may take several turns of the leveling
screw to allow the doors to close easier.
5. Check for door alignment. If one door is lower than the other,
adjust the leveling screw, on the lower side of the refrigerator.
Using a 1/4" hex driver, turn the screw clockwise to raise that
side of the refrigerator until the doors are aligned. It may take
several turns of the leveling screw to raise the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws.
6. Make sure the refrigerator is steady. If the refrigerator seems
unsteady or rolls forward when the door or drawer is opened
adjust the leveling screws. Using a 1⁄4" hex driver, turn the
leveling screw on each side clockwise until the rollers are up
and the leveling feet are firmly against the floor.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws.
7. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place.