Owner's Manual
Table Of Contents
- REFRIGERATOR SAFETY
- MAINTENANCE AND CARE
- Cleaning
- Changing the LED Module
- Water Filtration System
- Vacation and Moving Care
- INSTALLATION INSTRUCTIONS
- Unpack the Refrigerator
- Electrical Requirements
- Location Requirements
- Water Supply Requirements
- Connect the Water Supply
- REFRIGERATOR FEATURES
- Crisper Humidity Control
- DOOR AND HANDLE INSTRUCTIONS
- Refrigerator Doors and Drawer
- Remove and Replace Door Handles
- Remove Doors and Hinges
- Reverse Doors (optional)
- Replace Doors and Hinges
- Remove and Replace Freezer Drawer
- PERFORMANCE DATA SHEET
- Performance Data Sheet
- SÉCURITÉ DU RÉFRIGÉRATEUR
- Sécurité du réfrigérateur
- ENTRETIEN ET RÉPARATION
- Nettoyage
- Remplacer le module à DEL
- Système de filtration de l’eau
- Précautions à prendre avant les vacances ou le déménagement
- INSTRUCTIONS D’INSTALLATION
- Déballage du réfrigérateur
- Spécifications électriques
- Exigences d’emplacement
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- CARACTÉRISTIQUES DU RÉFRIGÉRATEUR
- Réglage de l’humidité dans le tiroir à légumes
- INSTRUCTIONS POUR LA PORTE ET LA POIGNÉE
- Portes et tiroir du réfrigérateur
- Consulter la section Retrait et réinstallation des poignées de porte
- Démontage des portes et charnières
- Inversion des portes (facultatif)
- Réinstallation des portes et charnières
- Retrait et réinstallation du tiroir de congélation
- FICHE DE DONNÉES DE PERFORMANCE
- Fiche de données de performance
9
� To remove the handle, grasp the lower part of the handle
firmly, slide the handle up and pull the handle straight out from
the door.
� To replace the handle, position the handle so that the large
holes in the mounting clips are down and align the holes with
the door studs. Rotate the handle so that the mounting clips
are flat against the door and slide the handle down to engage.
FREEZER DOOR HANDLES
Freezer Door Handle Style 1
A. 3/32” Setscrew
� Using a 3⁄32" or 1⁄8" hex key, loosen the two setscrews located
on the side of each handle. Pull the handle straight out from
the drawer. Make sure you keep the screws for reattaching the
handles.
� To replace the handles, reverse the directions.
Freezer Door Handle Style 2
A. Handle Trim C. Freezer Drawer Handle
B. Flat–Head Handle Screws
� Remove the screw cover.
� Remove the handle assembly. Keep all parts together.
� To replace the handles, reverse the directions.
Freezer Door Handle Style 3
A. Flat–Head Handle Screws
� Remove screws and handle.
� To replace handle, reverse directions.
Freezer Door Handle Style 4
A. Flat–Head Screws B. Freezer Drawer Handle
� Remove screws and handle.
� To replace the handles, reverse the directions.
Freezer Door Handle Style 5
� To remove the handle, grasp the lower part of the handle
firmly, slide the handle up and pull the handle straight out from
the door.
� To replace the handle, position the handle so that the large
holes in the mounting clips are down and align the holes with
the door studs. Rotate the handle so that the mounting clips
are flat against the door and slide the handle down to engage.
Remove Doors and Hinges
STANDARD DOOR
Hex Head Top Hinge Screw
Standard Door - Freezer drawer models
1. Unplug refrigerator or disconnect power
2. Keep the refrigerator door closed until you are ready to lift it
free from the cabinet.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door gasket
magnets to hold the door in place while you are working.