Instruction Sheet

Installation Instructions
for Pressure Regulator on Customer Supply Line
On Models: JFFCC72EFS04, JFFCC72EHL02, KRFC604FSS03, KRFC704FBS03, KRFC704FPS04,
KRFC704FSS03, WRF954CIHM02, WRF954CIHB02, WRF954CIHW02, WRF954CIHV02, WRF954CIHZ03
IMPORTANT:
■ Pressure regulator kit intended for use on the above
models to assist in the dispensing of water in households
with high water pressure.
■ Connect the pressure regulator to your water supply line in
accordance with all state and local codes and ordinances.
■ Make sure to turn off water supply before installation.
Kit Contains:
A. (1) Pressure Regulator
B. (1) Mounting Clip
C. (1) Screw
D. (2) Adhesive-backed Tubing Clip
E. (1) Installation Instruction (not pictured)
F. (1) Waterline-valve-regulator (not pictured)
NOTE: Attaching the pressure regulator will require a 2”
spacing from back of appliance to the wall. This may be
greater than before installation, causing the appliance to stick
out further.
Tools Needed:
■ PEX Tube Cutter –OR– Utility Knife
■ Phillips Screwdriver
■ Small container for draining the hose
■ Copper Tubing Cutter (If copper water line)
PREPARING THE APPLIANCE FOR SERVICE
1. Unplug appliance or disconnect power.
2. Turn the water off at the household supply.
3. If servicing a refrigerator, purge the product by dispensing
water for at least 30 seconds.
4. Locate the line connecting the household supply to the
A
D
B
C
D
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or electrical shock.
Replace all parts and panels before operating.
Figure 1
product. Disconnect the supply line from the household
side, using the container to catch the draining water. Do
not disconnect from the product.
INSTALLING THE PRESSURE REGULATOR
1. Use the provided 24" (61cm) long PEX water line.
2. Using the tube cutter or utility knife, cut the household
supply line at the measurement. Ensure that tubing is
cut square with no burrs, sharp edges, or deformation to
prevent leaking.
3. For bottom mount and side-by-side platforms, locate and
remove one of the center screws holding the machine
compartment cover in place. (If not available, locate a
similar location on the product.) See Figure 2.
4. Using the existing hole, attach the mounting clip with the
provided screw. Tighten screw so that the clip does not
freely rotate. See Figure 3.
5. Connect the pressure regulator in between the loose ends
of the water line by pressing the line ends rmly into the
pressure regulator’s connectors. See Figure 4.
IMPORTANT: Ensure that the water ow direction indicator
arrow on the pressure regulator is pointing in the direction of
the water ow (towards the appliance). Verify that the
connection is properly made by gently attempting to pull the
line straight out. If the line remains connected, the connection
was properly made.
EXAMPLE OF MOUNTING CLIP LOCATION
MOUNTING CLIP ATTACHED WITH SCREW
CONNECTING PRESSURE REGULATOR
FROM
SUPPLY
TO
APPLIANCE
WATER FLOW DIRECTION INDICATOR ARROW
W11502228A
Figure 2
Figure 4
Figure 3