Installation Instructions

Mounting the water valve

Refer to the diagram below for the following steps.

1. Locate the 2-pin water valve solenoid connector (with the

brown and two white wires) that is taped to the main wiring

harness at the lower right corner of the rear access

(see DETAIL A).

2. Refer to DETAIL B and insert the 2-pin connector over the

water valve solenoid terminals as far as possible (if the

harness is not long enough, break the tape holding it to the

main harness). You can position the connector with the wires

at either terminal.

3. Refer to DETAIL B and mount the water valve to the

mounting holes in the cabinet frame with two 1/2" hex-head

machine screws. Make sure that you tighten these two

screws securely.

NOTE: For side by side models with a metal access cover,

the valve is mounted to the valve bracket previously installed

instead of directly to the cabinet.

2-pin connector

Water valve

⁄2" hex-head

machine screws

DETAIL C

DETAIL A

DETAIL B

Brown

(2) White

2-pin connector

Water valve

1/2" hex-head

machine screws

Mounting the water valve