Installation Instructions

15
Refer to the side diagram for the following steps.
1. Take the two jumper harnesses included in the kit and
determine which one can connect to the freezer wiring
harness. Discard the other jumper.
2. Connect the compatible jumper harness to the ice maker
wiring harness. Route the wires over the guide and through
the wire clip in the ice maker.
3. Position the ice maker inside the freezer compartment and
connect its wiring connector to the jumper harness connector
so they lock together. The connectors will t together only
one way.
4. For Top/Upright Freezers Only: Hang the ice maker over the
two hex-head screws you installed earlier. Make sure that the
bottom mounting bracket hole is aligned with the mounting
hole in the freezer liner, then tighten the two top hex head
screws. Be sure not to overtighten the screws.
5. For Side-By-Side Models Only: Position the ice maker so that
its top and bottom mounting tabs are at against the side of
the freezer liner. Center the top tabs under the two mounting
clips, and push the ice maker straight up so that the mounting
clips snap over the tabs and lock into place (you should hear
them “click” as they lock).
6. Mount the bottom bracket of the ice maker to the freezer liner
mounting hole with a 1/2" hex-head sheet-metal screw.
7. Conrm ll tube extension reaches into the ll cup on the
ice maker. Install a di󰀨erent extension from the kit if the one
previously selected is too long or too short to dispense into
the ll cup with the ice maker mounted.
Wire
Clip
Guide
1/2" hex-head
sheet metal
screws
Bottom mounting
bracket
Tabs
Screws
Mounting the ice maker
(top and upright freezers)
1/2" hex-head
sheet metal
screws
Bottom mounting
bracket
Mounting the ice maker
(side-by-side models)
Ice
maker
Slide tabs
under clip
Insert ll
tube into
cup
Wire Clip
Guide
Tabs