Installation Instructions

8
Refer to the side diagram for the following step. You will be
working inside the freezer compartment.
1. Install the long plastic extension by sliding it over the ll tube
as far as it will go.
Refer back to the side diagram for the following step.
2. Position the wiring harness so that it is through the slot in
the wiring cover. Insert the tab at the back of the wiring cover
into the freezer liner slot. Press the pin on the side of the
wiring cover into the hole in the side of the freezer liner so it
locks into place. Secure the wiring cover with the screw you
removed earlier.
Proceed to “Installing the tubing clips” on page 11.
Slot
Fill tube
Wiring harness
Long ll tube extension
Installing the long ll tube extension
Insert pin
into hole
Hole
Wiring
harness
Wiring
cover
Pin Hole cover
Slot
Screw
Insert tab
into slot
Tab
Break o and discard
Ice maker wiring cover