Installation Instruction

Mounting the water valve

Refer to the diagram below for the following steps.

NOTE: For 11 Cubic Foot Top Freezer Models only, use a wire

tie to get together capillary tube and dryer. This should be done

by installer before installing water valve, to make more room for

water valve installation. Installer should move all thin tubing to

be in parallel with cabinet (refrigerator side wall). By doing this,

we assure that no copper tubing is above valve connector (see

DETAIL A).

1. Locate the 2-pin water valve solenoid connector (with the

brown and two white wires) that is tape to the main wiring

harness at the lower right corner of the rear access (see

DETAIL B).

2. Refer to DETAIL C and insert the 2-pin connector over the

water valve solenoid terminals as far as possible (if the

harness is not long enough, break the tape holding it to the

main harness). You can position the connector with the wires

at either terminal.

3. Refer to DETAIL C and mount the water valve to the

mounting holes in the cabinet frame with two 1⁄2" hex-head

machine screws. Make sure that you tighten these two

screws securely.

2-pin connector

Water valve

⁄2" hex-head

machine screws

DETAIL B

DETAIL C

(2) White

Brown

DETAIL A

Wire Tie

Dryer

Valve

connector

Mounting the water valve