Installation Instruction

9
Top/bottom freezer models
Refer to the side diagrams for the following 2 steps. You will be
working inside the freezer compartment.
1. On models with a open-top ice maker ll tube and wiring
cover:
Remove the screw from the ice maker
wiring cover.
Squeeze top and bottom to loosen snaps. Remove and
discard ice maker
wiring cover.
On models with a at cover:
Remove the screw from the ice maker
wiring cover.
Unhook the right side tab from the edge of the back cover.
Remove ice maker wiring cover.
Look at the back side of the at wiring cover and note the
grooved lines. Use a pair of pliers and bend the areas inside
the grooved lines back and forth until they break away from
the wiring cover.
2. Pull the 4-wire ice maker harness out from behind the
freezer’s back cover as far as possible, and hang it over the
edge of the cutout. Do not remove any other wiring from the
cutout.
Refer to the side diagrams for the following step. You will be
working on the back of the refrigerator cabinet.
1. On the back of the cabinet, peel off the label that is over the
ll tube hole.
On 11 Cubic Foot Top Freezer
Models ONLY (kit 24ECKMF)
Install "Bracket Fill Tube" in the refrigerator back. Use holes
in the back of refrigerator as reference.
Insert the ll tube through the hole in "Bracket Fill Tube" with
Spout, twist and lock Spout in place. Verify the Spout is held
in place by the "Bracket Fill Tube" ribs.
This type of x will not require any screws in the Spout at all,
screws will be inserted in the "Bracket Fill Tube".
Cover
Open to
p
fill tube
Snaps
Snap
Hex screw
Mounting hole
Removing wiring cover with open-top ll tube
Hex screw
Tab
Break off
and discard.
Mounting
hole
Wiring
cover
Removing the at wiring cover
Label
Remove
this label
for Ice Maker
installation
Removing the label
Spout
Fill tube
1
⁄
2
" hex-head
sheet-metal
screws
Bracket
fill tube
Ribs
Installing the ll tube/bracket ll tube
(11 cubic foot models)