Owner Manual

9
Adjust the Doors
Your refrigerator has two front adjustable levelers - one on the
right and one on the left. To avoid a hazard due to instability, if
your refrigerator seems unsteady or you want the doors to close
easier, adjust the refrigerator's tilt using the following instructions.
1. Turn the leveling leg to lower or raise that side of the
refrigerator. It may take several turns to adjust the tilt of the
refrigerator.
■ To raise, turn the leveling leg to the left.
■ To lower, turn the leveling leg to the right.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling legs and rollers
which makes it easier to adjust.
2. Open both doors again to make sure they close as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling legs to the left; it may take several more
turns.
NOTE: To keep the refrigerator level, you should turn both
leveling legs the same amount.
3. Using a level, be sure that the refrigerator is still level side to
side. Readjust if necessary.
REFRIGERATOR USE
Using the Controls
Your refrigerator has a high-tech, easy-to-use electronic control
feature located on the inside of the refrigerator compartment.
The rst time you plug in the refrigerator:
The rst time you plug in your refrigerator, all of the electronic
control indicators will ash simultaneously.
Temperature Control
Your refrigerator is equipped with a Smart temperature control.
You can use it to set the refrigerator compartment temperature as
needed.
To set the refrigerator compartment temperature:
The product is set to the recommended temperature at the
factory. To adjust that temperature, simply press the Setting
button. This will decrease the refrigerator temperature. The
setting change is unidirectional, from Cold to Coldest (left to
right). Once the control is in the Coldest position, it will move to
the least-cold setting (Cold) if pressed again.
This is the coldest temperature (Coldest) in the product. All the
indicators will be ON.
The least-cold temperature setting will be shown with the rst
indicator (left to right) ON.
The median minimum temperature will be displayed when you
press the Setting button once from the least-cold temperature.
The second indicator will be ON.
The “Recommended” temperature will be shown with the third
indicator ON.
The fourth indicator will come on when you press the Setting
button once from the recommended temperature.
NOTE: To switch off the refrigeration system, press the Setting
button for 4 seconds and then release it. No indicator will remain
on. This will lead the refrigerator and freezer to stop cooling, but
the electricity is not disconnected.
To switch the refrigeration system back on, press the Setting
button for 4 seconds and then release it.