Operation Manual

The dishes were not
loaded correctly .
See notes in " Loading the Dishwasher Baskets ".
Select a more int ensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the direction s.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishw a sher immediately after
washing. Open the door slightly so that the st eam can
escape. Begin unloading the dishwasher only once t
he dishes are barel y warm to the touch. Empty the low
basket fir st. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more d ifficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerf ul enough.
Not eno ugh deter gent
was dispensed.
Items are blocking
the path of sp ay arms.r
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are r emoved
too soon
Wrong program
has been selected
Use of cutlery with
a low-quality coating
Malfunction of temperature sensor or of heating
element.
Short circuit or break of temperature sensor
Open circuit or break of temperature sensor
Longer heating time,
but not reaching required temperature
Overflow .
Failure of temperature sensor
Failure of temperature sensor
Wh en some m alfunctions com e on, the appliance w ill display error code s to warn you:
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
Longer inlet tim e.
Fau cets is not opened, or water intake is restricted,
or water pressure is too low.
Some element of dishwasher leaks .