User's Manual

23340-4-0608 Page 13
Flush Wall Installation
Figure 13
Combustible Surround Installation
Figure 14
Attention: Cold climate installation recommendation: When
installing this unit against a non-insulated exterior wall, it is
recommended that the outer walls be insulated to conform
to applicable insulation codes.
Vent Runs (Figures 15, 16, 17, 18, and 19)
In planning the installation for the fireplace, it is necessary to
install certain components before the appliance is completely
positioned and installed. These include the direct vent system,
gas piping for the appliance and the electrical wiring. (If the fan
option is used.)
The appliance can be mounted on any of the following surfaces:
1. A flat, hard combustible (burnable) surface.
2. A raised wooden platform.
3. Four (4) corner supports. (Example: Four (4) concrete masonry
blocks.) These supports must be positioned so they contact all
four (4) perimeter edges on the bottom of the unit.
VERTICAL, 90° ELBOW WITH HORIZONTAL
TERMINATION
Figure 15
3! OF NON-COMBUSTIBLE MATERIAL
FINISHED WALL
FRONT TRIM O
R NON-
COMBUSTIBLE MA TERIAL
(INSTALLA TION IS OPTIONAL)
JOINT BETWEEN FINISHED
WALL AND UNIT SEALED
WITH 300° F, 149° C SEALANT
MATERIAL
(Sealant is optional)
DVP36
49 ½”
(126
mm)
TO BOTT OM
OF UNIT
VENT CAP/
THIMBLE
THIMBLE
3! OF NON-COMBUSTIBLE MATERIAL
FINISHED WA
LL
FRONT TRIM
OR NON-COMBUSTIBLE
MATERIAL (INSTALLATION I
S OPTIONAL)
JOINT BETWEEN FINISHED WA
LL AND
UNIT SEALED WITH
300° F 149
MATERIAL (SEALANT IS OPTIONAL
)
° C
SEALANT
COMBUSTIBLE SURROUND
MANTELSHELF
2 X 4
HEADER
STAND OFF
LP and Nat models