Manual

HOW YOUR AIR CLEANER WORKS (See figure 1.)
Dirt laden air enters the unit from the room. It passes
through the screen (A) first where large particles (hair, lint,
etc.) are trapped. Smaller particles (smoke, dust, pollen,
etc.) passthrough this screen and enter the Ionizing Section
(B). Here each tiny particle receives a positive electrical
charge. These charged particles then enter the Collection
Section (C) which consists of a series of aluminum
plates.., alternate plates are charged positive.
The positive charged particles are repelled by the positive
plates and attracted to the negative plates where they are
collected - just as a magnet attracts iron filings.
b
A B C
Figure I
Jill i i i i i i i i J t J it
UNPACKING AND INSPECTION
1. Unpack and carefully remove air cleaner from carton.
2. Stand air cleaner upright on floor.
3. Release two knurled screws (F]G. 2) at upper edge of
grille, open grille and slide it out of hinges at bottom by
moving it to the left.
4. Rotate two screen retainer latches either left or right to
clear screen. Lift screen out.
5. Remove three screws, one at each end and one at
center of electrical enclosure cover and remove cover.
6. Grasp the two spring clips at the points (A, FIG. 3) and
pull the cell out at the bottom. The collection cell will
move outward approximately three inches where it will
be retained by the safety spring clip at location (B,
FIG. 3). Depress this safety spring clip to free the cell
at the bottom.
7. Grasp the cell at both sides and tilt it rearward at the
top to slide the retaining pins out of their slots and lift
the cell out of the cabinet. Place cell in a safe location•
SCREEN RETAINER SCREEN
LATCH
KNURLED SCREWS /
lr .it
lr it
11 lr
"If 11
_1 r "1 I"
1
1
1
--1
1
1
1
I 1
1
/
GRILLE
SCREEN CLIP
HINGE
Figure 2
A
SPRING CLIPS
ELECTRICAL ENCLOSURE COVER
\
IIIU
CE
Figure 3
3