User's Manual
14 | P a g e
SETTING SWITCH OFF TIMER
With the air conditioner operating in any function mode, press the Timer Control button .
Then the and the two digits timer indicator will come on. Set the desired time delay OFF
hours (1 – 24 hours) by pressing the up or down buttons. When the delay time set has elapsed,
the air conditioner will switch off.
To cancel the switch off timer, press the Timer Control button and set the hour to 00.
SETTING DELAYED SWITCH ON TIMER
When the air conditioner is off, press the Timer Control button . Then the and the two
digits timer indicator will come on. Set the desired time delay ON hours (1 – 24 hours) by
pressing the up or down buttons. When the delay time set has elapsed, the air conditioner will
switch on in the previous setting.
To cancel the switch on timer, press the Timer Control button and set the hour to 00.
AUTO RESTART
In the event of a power outage, the air conditioner restarts at the previously set function mode
and settings when power is restored.
NOISE LEVEL
Portable air conditioners may make sounds that are not familiar to you. The sounds listed below
are normal. Noise reflecting off hard surfaces such as a floor or wall can make the sounds seem
louder than they actually are.
The compressor may make a pulsating or high-pitched sound.
Water running from the evaporator to the water tank may make a splashing sound.
Refrigerant flowing may make a gurgling sound.
Fan sound may come from front and back air vents.
WATER DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. Most of
this water is used to cool and exhausted to the outside. If the unit is operated in high humidity or
low temperature environment, water will collect in the reservoir inside the unit. If the reservoir is
full, the compressor will stop. To continue the cooling function, please drain the water.
Manual drain:
1. Turn off the unit.
2. Position a flat container or dish under the drain plug.
3. Remove the drain plug and the condensed water will drain out automatically.
4. Once all the condensed water is drained, replace the drain plug into the drain firmly.
Continuous drainage:
In COOL or DRY modes, remove the upper drain plug from the back of the unit and put a
container under the drain port to catch the water. Or install the drain water hose and place the
open end of the hose to a drain area.