Specifications Sheet

OPERATION INSTRUCTIONS

 The temperature setting range of this air conditioner is from 61F to 77F. To set the temperature, press the + or –

buttons. Once the set temperature is achieved, the compressor and the fan will stop

NOTE: This unit uses heat pump from heating and the heating mode does not work when temperature is below

45F.

 To set the fan speed, press the Fan Speed button. In Heating mode, the difference in noise level between the 3

fan speeds is not very noticeable when the compressor is on. Try setting the unit to Fan only mode, you should

be able to hear the difference between high and low fan speed settings.

 Please note that in Heat mode, the unit may need to be drained more often as the self evaporating function is not

applicable in this mode.

HEAT PUMP FUNCTION

In Heating mode, the heat pump reverses the cooling sequence and produces heat instead of cooling the indoor en-

vironment. The evaporator coil switches function and becomes the condenser coil. The condenser also switches

roles to serve as the evaporator, and discharges cold air.

TIMER (DELAYED SWITCH ON / OFF) FUNCTION

This function mode enables a delayed switch ON or delayed switch OFF of the air conditioner. The time (hours) de-

lay can be set, enabled and disabled. The timer is adjustable between 1 - 24 hours.

SETTING SWITCH OFF TIMER

With the air conditioner operating in any function mode, press the Timer button. The display timer setting will come

on. Set the desired time delay OFF hours by pressing the and buttons. The time increments are at 1 hour to up to

24 hours. When the delay time set has elapsed, the air conditioner switches off. To cancel the delayed switch off

function, press the Timer button or turn off the air conditioner.

SETTING DELAYED SWITCH ON TIMER

With the air conditioner is off, press the Timer button. The display timer setting will come on. Set the desired time

delay ON hours by pressing the and buttons. The time increments are at 1 hour to up to 24 hours. When the de-

lay time set has elapsed, the air conditioner switches on. To cancel the delayed switch on function, press the Timer

button or turn on the air conditioner.

AUTO RESTART

In the event of a power outage, the air conditioner restarts at the previously set function mode and settings when

power is restored.

NOISE LEVEL

Portable air conditioners may make sounds that are not familiar to you. The sounds listed below are normal. Noise

reflecting off hard surfaces such as a floor or wall can make the sounds seem louder than they actually are.

 The compressor may make a pulsating or high-pitched sound

 Water running from the evaporator to the water tank may make a splashing sound

 Refrigerant flowing may make a gurgling sound

 Fan sound may come from front and back air vents

COMPRESSOR LOCK OUT

This portable air conditioner is optimized to operate in an ambient temperature of 64°F – 90°F. The compressor cir-

cuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents over-heating of

the compressor and possible circuit breaker tripping.

WATER DRAINAGE

During the process of cooling, some water will be extracted from the air into the unit. Most of this water is used to

cool and exhausted to the outside. If the unit is operated in high humidity or low temperature environment, water will

be collected in the reservoir inside the unit. If the reservoir is full, the compressor will stop. To continue the cooling

function, please drain the water. See page 9.