Instruction Manual

10
Operation and Controls
Power
Temperature
Humidity
Light
LEVELING THE APPLIANCE
It is important for your appliance to be leveled in order to work
properly. It can be raised or lowered by rotating each of the feet
leveling legs on the bottom of the machine. If you find that the
surface is not level, rotate the feet leveling legs until the
appliance becomes level .You may need to make several
adjustments to level it. We recommend using a carpenter’s level
to check the machine
Note: This unit has 3 large leveling legs and 1 small leveling leg
under the door hinge.
1. Place a carpenter’s level on top of the product to see if the
appliance is level from front to back and side to side.
2. Adjust the height of the leveling legs as follows: Turn the
leveling leg to the right to lower that side of the refrigerator.
Turn the leveling leg to the left to raise that side of the
refrigerator.
HUMIDITY CONTROL
 This appliance is equipped with a humidity maintenance system to
ensure the humidity levels are maintained. Fill the humidity tray with
100% distilled water. Install the wick filters in the filter slots. These
filters remove minerals and physical impurities from the water before
evaporation, helping prevent mineral deposits from the water.
Note: The humidity tray should not be filled with propylene glycol
solution or humidity beads. If propylene glycol solution or humidity
beads are preferred, they can be placed in another area of the
cabinet.
 Check the water level regularly and refill as needed.
 Replace the wick filters every 3-6 months. Contact Whynter
Customer Support for purchase information.
Wick Filters
Humidity Tray
Suitable water level
Distilled water
SETTING THE TEMPERATURE
The interior temperature range of 64°F - 72°F (18° - 22°C) can be adjusted in increments of +1 degree. You can
set the temperature by pressing the Temperature button on the control panel. The temperature range cycles
back to 64°F if the temperature button is pressed at 72°F. The advanced compressor cooling system also
includes an integrated heating system that will automatically heat as needed to maintain the set temperature
within 1°F - 5°F.
SETTING THE HUMIDITY
The interior humidity range of 65% - 75% can be adjusted in increments of +1 percent. You can set the humidity
by pressing the humidity button on the control panel. The interior humidity range cycles back to 65% if the
humidity button is pressed at 75%.
INTERIOR LIGHT
You can turn on and off the interior light by pressing the “Light” button on the control panel.