Instruction Manual

Installation
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
 Remove the exterior and interior packing.
 Clean the interior surface with lukewarm water using a soft cloth.
 Install the handle on the door
HANDLE BAR
To install the handle, you will need a Phillips head
screwdriver.
1. Open the door.
2. Locate the two screw holes on the inside of the door
(they may be partially obscured by the door seal so
you may need to remove the door seal).
3. Insert the screws into the screw holes until they stick
out of the front of the door.
4. Line up the holes in the handle with the screws and
give each screw about 2-4 full turns into the handle
bar.
5. Now the turn the screws in all the way, and your
han-dles are installed.
6. Replace seal into door frame.
WARNING
To reduce the risk of fire, electrical shock, or
injury when using your appliance, follow these
basic precautions:
 Read all instructions before using the appliance.
 DANGER or WARNING: An empty cigar cooler humidor can be a hazardous for chil-
dren or small pets. If disposing of the cigar cooler humidor, remove gasket seals, latches,
lids or the entire door from your unused appliance, or take other action to ensure the ap-
pliance is harmless.
 Never allow children to operate, play with, or crawl inside the appliance.
 Never clean appliance parts with flammable fluids or harsh chemicals. The fumes can create a fire
hazard or explosion.
 Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any
other appliance. The fumes can create a fire hazard or explosion.
SCREWS
DOOR
SEAL
HANDLE
BAR
DOOR
SEASONING THE UNIT
Before placing any cigars inside of the unit, the inside should be seasoned. This step is very important as cedar is a low density
wood so the hydroscopicity is relatively large. Seasoning will allow the wood to absorb and hold moisture so that it does not
absorb additional moisture once cigars are added.
• Before placing any cigars inside of the unit, wipe the inside of the cabinet walls, drawers and shelves with 100% distilled water.
• Add 100% distilled water into the humidity tray.
Note: The humidity tray should not be filled with propylene glycol solution or humidity beads.
• Ensure the humidity range is over 65% before placing any cigars inside of the unit. This step may take a few days depending on
ambient conditions.
• Load the cabinet with cigars making sure not to block the internal fan(s)/ vents. More moisture may be needed after adding the
cigars as they will naturally absorb some of the moisture from the cabinet.
8