WHYNTER COMPACT PORTABLE ICE MAKER Model # : IMC-270MS INSTRUCTION MANUAL Congratulations on your new Whynter product. To ensure proper operation, please read this Instruction Manual carefully before using this product. Keep this manual in a safe place for future reference.
DISPOSAL INFORMATION Thank you for choosing the Whynter Portable Ice Maker. Please follow the instructions provided in this user guide to obtain the very best performance from your Ice Maker. We trust that your Whynter Portable Ice Maker will provide the performance and reliability that we stand for. Please keep this user manual in a safe place for future reference.
TABLE OF CONTENTS / TECHNICAL SPECIFICATIONS TABLE OF CONTENTS DISPOSAL INFORMATION 2 TECHNICAL INFORMATION 3 SAFETY PRECAUTIONS 4 PARTS 5 CONTROL PANEL AND FEATURES 6 INSTALLATION AND OPERATING INSTRUCTIONS 7–8 CARE AND MAINTENANCE 9 TROUBLESHOOTING 10 WARRANTY INFORMATION 11 TECHNICAL SPECIFICATIONS MODEL : IMC-270MS Protection Type: I Climate Type: SN/N/ST Power Consumption: 120W Power Supply: 115V/ 60Hz Water Reservoir Capacity: 2.2L Ice Making Current: 1.
SAFETY PRECAUTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY WHEN USING YOUR PORTABLE ICE MAKER, FOLLOW THESE BASIC PRECAUTIONS: Read all instructions before using the appliance Never clean appliance parts with flammable fluids. The fumes can create a fire hazard.
PARTS 1 Ice Shovel 2 Ice Full Sensor 3 Ice Basket (Removable) 4 Ice Maker Cover 5 Air Vent 6 Water Drain Plug 7 Maximum Water Level Mark and Water Reservoir 8 Control Panel 5
CONTROL PANEL AND FEATURES A Cube Size Indicator Lights B Power Indicator C Ice Full Indicator D Water Shortage Indicator Light E Power On/Off Button F Cube Size Selector Button ICE SIZE ICE SIZE SELECTION This ice maker produces bullet-shaped ice. The default cube size from the factory is set at LARGE. Each time you press this button the cube size selection will change between Small and Large. The chosen mode shall stay as selected unless changed or there is a power failure.
INSTALLATION AND OPERATING INSTRUCTIONS INSTALLATION OF YOUR ICE MAKER Locate the ice maker away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the ice maker not to perform properly. Plug the ice maker into an exclusive properly installed-grounded wall outlet.
INSTALLATION AND OPERATING INSTRUCTIONS NOTE: This ice maker produces 9 ice cubes every cycle of 10 to 15 minutes approximately depending on the size of cube is selected. When the ambient temperature is lower than 59ºF, the small ice cube size is recommended to avoid ice cubes clumping together. For best performance, water temperature should be between 55ºF and 85ºF and ambient temperature between 65ºF and 77ºF. NOTE: The ice basket does not keep the ice cubes frozen.
CARE AND MAINTENANCE CAUTION : Failure to unplug the ice maker could result in electrical shock or personal injury. DRAINING YOUR ICE MAKER Follow the steps below to drain the unit. 1. Carefully move the unit towards a sink or other suitable location for draining 2. Remove the rubber drain plug from the bottom of the water reservoir to drain all the water. 3. Let the water drain from the drain plug. 4. Firmly install the rubber drain plug into the drain port.
TROUBLESHOOTING Problem The compressor works abnormally with a buzzing noise Possible Causes Solutions The voltage is lower than recommended Stop the ice maker and do not restart until the voltage is normal Water shortage indicator light There is not enough water in is on the reservoir Press the ON/OFF button, fill with water, wait 3 minutes and press the power button again to restart Ice full indicator light is on Ice basket is full to the top Remove some of the ice Indicator
ONE YEAR LIMITED WARRANTY This WHYNTER Portable Ice Maker is warranted, to the original owner within the 48 continental states, for one year from the date of purchase against defects in material and workmanship under normal use and service.