Installation Guide

Installation

 A standard electrical supply (115 VAC only, 60 Hz, 10A), properly grounded in accordance with National

Electrical Code and local codes and ordinances is required.

 IMPORTANT: Do not kink or pinch the power supply cord between the upright freezer and wall or cabinet.

MOVEMENT OF YOUR APPLIANCE

 Position the upright freezer in a dry and well-ventilated place. Keep the upright freezer away from direct sun-

light, heaters, and corrosive gases or chemicals.

 Clean the interior surface with lukewarm water using a soft cloth.

 Place your appliance on a hard and level floor that is strong enough to support it when it is fully loaded.

 The upright freezer can be simply moved from one room to another by using the pre-installed wheel rollers.

If the appliance is needed to be lifted, two or more people should move upright freezer. Failure to do so can

result in back or other injury.

 We do not recommend installing the appliance on carpet.

DOOR INSTALLATION

This appliance includes a door handle that is not required for opera-

tion. To install the handle, please follow the instructions below:

 Install the two screws onto the door holes as shown. Make sure

that the screws are securely installed.

 Carefully line up the door handle to the installed screws.

 Secure the door handle in place by tightening the pre-installed

recessed screws using the wrench provided.

LEVELING THE UPRIGHT FREEZER

It is important for the upright freezer to be leveled in order to work

properly. It can be raised or lowered by turning the two feet on the bot-

tom of the machine. If the upright freezer is not leveled during installa-

tion. The doors may not close or seal properly, causing cooling, frost,

or moisture problems. It is very important that the upright freezer is at

level in order to function properly.

NOTE: This upright freezer comes with 2 leveling legs and 2 wheel

rollers

We recommend using a carpenter’s level to check the machine.

 Place a carpenter’s level on top of the product to see if the upright

freezer is level from front to back and side to side.

 Adjust the height of the feet as follows:

 Turn the leveling feet to the right to lower that side of the upright freezer

 Turn the leveling feet to the left to raise that side of the upright freezer