User manual
FX 250 / FX 500 User Manual
86
VI. PPPoE
By default, the PPPoE is disabled.
1. Select Enable.
2. Click Update.
3. Once the PPPoE service is enabled, a pop-up message box indicates the PPPoE
service is acvated and requires reboong of terminal for the service to take eect
VII. Seng
You can select the Ethernet mode to be used for data connecon.
Follow these steps to select the Ethernet mode:
1. Select the desired mode to be used during the data connecon:
• Router (Single User) is with NAT/PAT disabled
• Router (Mul-User) is with NAT/PAT enabled for mul-user.
Note:
You cannot change the Router sengs while a Data connecon is acve, you must
rst disconnect your Data session.
2. Check “Always On (Auto PDP Context Acvaon)” if required.
3. Click Update to allow the selecon to take eect.
4. Click Refresh to query the current mode.