Use and Care Manual

#11128, Utility Workshop Vise (model 676)

Replacement parts

Spindle and

Handle

Assembly

Serrated Jaw

Inserts

w/Screws

Spindle Nut

Lock Nut and

Bolt Assembly

Outer Ring

w/ Bolt

Spring,

Washer,Clip

Assembly

Swivel Base

Assembly

Thrust Bearing

Washer

87005-21 11128S41 11115-15 11104S51 2900690 11104S25 2900730 11128-1

To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model

Number and Serial Number of your tool available when you call will allow us to serve you quickly and accurately. Some parts are shown for

reference only, and may not be available individually.

Specifications

Stock no.

11128

Model no. 676

Jaw width (in.) 6-1/2

Jaw opening (in.) 5-1/2

Throat depth (in.) 3-13/16

Pipe jaw capacity (in.) 1/8–2-1/2

Shipping weight (lb) 43

WILTON

427 New Sanford Road

LaVergne, Tennessee 37086 Part No. M-11128

Ph.: 800-274-6848 Rev. H1 08/2018

Note: See reverse side for important safety instructions.

PAGE 1
#11128, Utility Workshop Vise (model 676) Replacement parts Spindle and Handle Assembly A Serrated Jaw Inserts w/Screws B 87005-21 11128S41 Spindle Nut C Lock Nut and Bolt Assembly D Outer Ring w/ Bolt E Spring, Washer,Clip Assembly F Swivel Base Assembly G Thrust Bearing Washer H 11115-15 11104S51 2900690 11104S25 2900730 11128-1 To order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS • Misuse of vise can cause serious injury to eyes, hands, limbs, etc. • To ensure safety, vise must be set up and used properly. • Before setting up and using, read, understand, and follow all instructions as outlined below. When setting up vise: • Use proper size bolts, nuts, lock and flat washers, in all base mounting Holes. Never weld base of vise to any metal object. • Only hand-tighten swivel base lock down nuts at the sides of the vise.