Specifications

SAFETY
5
Keep all wheel guards in place. Do not use the
grinder with the wheel guard removed.
Do not try to cut anything with the grinding
wheel.
ELECTRICAL REQUIREMENTS
WARNING:
• Use only manufacturer’s recommended replacement parts, or
equivalent, when servicing this tool.
• Do not touch the metal blades on the power cord plug when
removing or installing the plug into an electrical outlet.
• To avoid electrical hazards, fire hazards, or damage to the
tool, use proper circuit protection.
Your bench grinder is wired at the factory for 120V
operation. Connect to a 120V, 15 AMP time delayed
fuse or circuit breaker. To avoid shock or fire, replace
power cord immediately if it is worn, cut or damaged in
any way.
Use a separate electrical circuit for your tools.
This circuit must not be less than a #12 wire and
should be protected with a 15 Amp time delayed fuse.
Before connecting the motor to the power line, make
sure the switch is in the OFF position and the electric
current is rated the same as the current stamped on
the motor nameplate. Running at a lower voltage will
damage the motor.
When operating a power tool outside, use an
outdoor extension cord marked "W-A" or "W". These
cords are rated for outdoor use and reduce the risk of
electric shock.
WARNING: This bench grinder is for indoor use only.
Do not expose to rain or use in damp location. This tool must be
grounded while in use to protect the operator from electrical
shock.
Do not modify the power cord plug. If it does not
match the electrical outlet, have the proper outlet
installed by a qualified electrician.
SAVE THESE SAFETY INSTRUCTIONS