Owner manual

Exploded Assembly Diagram

SRP DRILLED/SLOTTED

PATTERN ROTOR

EXISTING

BOLT

HP PLAIN FACE PATTERN ROTOR

EXISTING NUT

EXISTING AXLE,

BEARING, AND

FLANGE.

RIGHT HAND INSTALLATION

SHOWN

Figure 1. Typical Installation Configuration

WARNING

INSTALLATION OF THIS KIT SHOULD ONLY BE

PERFORMED BY PERSONS EXPERIENCED IN

THE INSTALLATION AND PROPER OPERATION

OF DISC BRAKE SYSTEMS.

NOTE

SPECIFIC PARTS MAY VARY FROM DIAGRAM

Important Notice - Read This First

Before any tear-down or disassembly begins, review the following information:

• Review the Wheel Clearance Diagram (Figure 2, page 3) to verify that there is adequate clearance with the

wheels you will be using with the installation.

• Rear brake kits are not supplied with hydraulic lines or fittings and may require the purchase of additional

lines or fittings to complete the installation. Wilwood offers an extensive listing of brake lines and fittings on

our web site: www.wilwood.com.

• Rear brake kits are not supplied with parking brake cables hardware or adapters. Please see the note in the

assembly instructions for vendor recommendations to purchase these parts.

• Due to OEM production differences and other variations from vehicle to vehicle, the fastener hardware and

other components in this kit may not be suitable for a specific application or vehicle.

• It is the responsibility of the purchaser and installer of this kit to verify suitability / fitment of all components

and ensure all fasteners and hardware achieve complete and proper engagement. Improper or inadequate

engagement can lead to component failure.

Page 2

Photographic Tip

Important and highly recommended: Take photos of brake system before disassembly and during the disassembly process. In the

event, trouble-shooting photos can be life savers. Many vehicles have undocumented variations, photos will make it much simpler for

Wilwood to assist you if you have a problem.