Use and Care Manual

Table Of Contents

make repairs as necessary: (1) interlock operation, (2) proper

door closing, (3) seal and sealing surfaces (arcing, wear, and

other damage), (4) damage to or loosening of hinges and latches,

(5) evidence of dropping or abuse.

inspection within the microwave generating compartments, check

the magnetron, wave guide or transmission line, and cavity for

proper alignment, integrity, and connection.

(d) Any defective or misadjusted components in the interlock,

monitor, door seal, and microwave generation and transmission

systems shall be repaired, replaced, or adjusted by procedures

described in this manual before the oven is released to the owner.

(e) A microwave leakage check to verify compliance with the

Federal Performance Standard should be performed on each

oven prior to release to the owner.

GROUNDING INSTRUCTI ONS

This appliance must be grounded. In the event of an electrical

short circuit, grounding reduces the risk of electric shock by

providing an escape wire for the electric current. This appliance is

equipped with a cord having a grounding wire with a grounding

plug. The plug must be plugged into an outlet that is properly

installed and grounded.

WARNING – Improper use of the grounding can result in a risk of

electric shock. Consult a qualified electrician or serviceman if the

grounding instructions are not completely understood, or if doubt

exists as to whether the appliance is properly grounded, and

either:

1) If it is necessary to use an extension cord, use only a 3-wire

extension cord that has a 3-blade grounding plug, and a 3-slot

receptacle that will accept the plug on the appliance. The marked

rating of the extension cord shall be equal to or greater than the

electrical rating of the appliance, or

2) Do not use an extension cord. If the power supply cord is too

short, have a qualified electrician or serviceman installs an outlet

near the appliance.