Full Product Manual

PAGE 11
winchestersafes.com Owner’s Manual
MECHANICAL SAFE LOCKING INSTRUCTIONS
STEP 1- Make sure there is not any obstruction inside the safe that will block the door
from closing or the movement of the locking bolts; close the door and rotate the handle
counterclockwise until it comes to a solid stop.
STEP 2 - Turn the dial counterclockwise at least three revolutions. Your safe is now
locked.
ELECTRONIC LOCK OPERATING AND CHANGING INSTRUCTIONS
The Combination for this safe was preset at the factory to 1-2-3-4-5-6. The combination
can be changed to any six (6) digit combination of your choice.
STEP 1: INSTALLING THE BATTERY
The battery is located inside the keypad. To install the battery, nd
the sliding door at the bottom of the keypad that provides access
to the battery. Slide the door to the right to open. Gently pull the
battery connector and wires down. Attach a new 9-volt ALKALINE
battery to the connector (ENERGIZER® or DURACELL® only). Gently
push the battery and wires up into the compartment and close
the sliding door by sliding it to the left. The lock is now powered
and ready for use.
STEP 2: OPENING THE DOOR FOR THE FIRST TIME
If entered correctly, you will hear one (1) beep after each entry and two (2) beeps after
entering the last number. The two (2) beep sound is your indicator that you have entered
the correct combination. If you hear three (3) beeps, you have incorrectly entered the
• Enter the factory set combination 1-2-3-4-5-6
• Turn handle clockwise to open the safe
Key Pad
Battery _____
Connector
9V Alkaline
Battery
Battery
Door