Installation manual

6. If search satellite and search method is correct (correct city, elevation, etc.)

return the positioner to factory default. See Return To Defaults, page 6.

If after returning the positioner to factory defaults and reentering the correct city

and satellite the system still does not find the satellite proceed to the next step.

You will need a voltmeter or Winegard Model TE-1400 voltage tester for steps

7 through 10.

7. Check for +12 to +19 VDC at LNBF coax connector, see Figure 2. If correct

voltage is present, proceed to step 11; if there is no voltage, proceed to next

step.

8. Remove the coax downlead from the SAT IN jack on the rear of satellite

receiver. Connect a short piece of coax to the SAT IN jack on receiver, check

for +12 to +19 VDC. If voltage is correct proceed to step 9; if voltage is not

present verify the receiver is plugged into AC power. If there is no voltage

coming out of the SAT IN jack on the receiver, contact the manufacturer of the

receiver. RCA 800-377-3399, Sony 800-838-7669, Dish Network 800-333-

3474.

9. Remove coax downlead from TO RECEIVER jack on positioner. Check for

+12 to +19 VDC at coax connector. If voltage is correct proceed to step 10; if

voltage is not present verify the receiver is plugged into AC power and coax is

connected to SAT IN jack on receiver. If there is no voltage, the coax is

defective, repair/replace as required.

10. Reattach coax to TO RECEIVER jack on positioner. Remove the coax

downlead from the TO ANTENNA jack on positioner. Connect a short piece of

coax to the TO ANTENNA jack on positioner, check for +12 to +19 VDC. If

voltage is correct, the coax coming from the antenna is defective. Repair/

replace as required. If voltage is not present, verify the receiver is plugged into

AC power. No voltage coming out of the TO ANTENNA jack on positioner

indicates that positioner is defective. Contact Winegard Service Department

before returning unit to be repaired.

11. Replace LNB with new one. If system still will not find satellite, replace

positioner. If system still does not find a satellite, contact Winegard Service

Dept.

Figure 2

Coax Center

Conductor