Installation manual

6. Press [SELECT A] Test LNB, see Figure 23. The positioner will display

the menu shown by Figure 24.

Model RD-9900

PINNACLE

POSITIONER

by WINEGARD

SELECT B

SELECT A

5. Press SELECT A Test LNB

Test LNB

Test Remote Panel

Figure 23

Model RD-9900

PINNACLE

POSITIONER

by WINEGARD

SELECT B

SELECT A

Antenna = 0 dB

Level = 954

Figure 24

Pressing the UP arrow

button will increase

attenuation by +4 dB

Antenna attenuation level,

this will vary from 0 to 28 dB

Pressing the DOWN arrow button will

decrease attenuation by -4 dB

Signal level, max. is 1024

min. is 0

7. The attenuation can be lowered or raised by pressing the UP/DOWN arrow

buttons in 4 dB increments. With the attenuation set at 0 dB and the antenna

NOT pointing at a satellite, the level should be greater than 900. As attenuation

is added the signal level should drop. With the attenuation set at 28 dB, the

signal level should be below 200.

If any of the above signal levels are not met, check that LNB is connected

to coax downlead. If coax is connected to LNB, contact Winegard service Dept.

for further troubleshooting assistance.

8. To exit the Test LNB menu, press either [SELECT A or B].

9. To exit Edit menu, press [UP/DOWN] arrow button until Quit is displayed.

10. Press [SELECT A or B] as appropriate.