User's Manual

ManualsBrandsWinegard ManualsTV ReceiverWinegard TV Receiver VS-0503

WINEGARD

ENTERTAINMENT SELECT

MODEL VS-0503/VS-5312

Model shown has five inputs, three outputs.

FEATURES:

• Simple push button controls allow you to send signals

from any one of 5 different inputs to 2 TVs and VCR.

• 5 Inputs are Satellite Receiver, TV Antenna, VCR,

Cable TV & Auxiliary.

• 3 Outputs: Main TV, TV 2, VCR.

• Built-in +12 VDC TV antenna power supply eliminates

need for separate wall mounted TV antenna power supply.

• Self-resetting fuses used in antenna power supply

prevent failure caused by shorted connections.

• Video switch allows for independent viewing of

signals at different TVs, with a record option from VCR.

•

Low profile housing blends

nicely with other electronic

components; fits easily in

overhead cabinets.

• Shielded circuitry for high

isolation and low signal loss.

• Oversize, easy-to-read graphics

for proper function selection

when mounted in out of the way

locations.

Summary of content (4 pages)

PAGE 1
WINEGARD® ENTERTAINMENT SELECT MODEL VS-0503/VS-5312 Model shown has five inputs, three outputs. FEATURES: • Simple push button controls allow you to send signals from any one of 5 different inputs to 2 TVs and VCR. • 5 Inputs are Satellite Receiver, TV Antenna, VCR, Cable TV & Auxiliary. • 3 Outputs: Main TV, TV 2, VCR. • Built-in +12 VDC TV antenna power supply eliminates need for separate wall mounted TV antenna power supply.
PAGE 2
COAX CABLE CONNECTIONS STEP 1. Connect the coax cable from the output on the switch box marked “To Main TV” to the antenna input connection on the back of the main TV. STEP 2. Connect the coax cable from the output on the switch box marked “To TV 2” to the antenna input connection on the back of the second TV. STEP 3. Connect the coax cable from the output on the switch box marked “To VCR” to the input connection on the back of the VCR. STEP 4.
PAGE 3
OPERATION Once all the connections have been properly made to the control box, you are ready to watch your favorite programming. USING THE BUTTONS ON THE FRONT OF THE CONTROL BOX VIEWING STEP 1. To view signals from an amplified TV Antenna, first press the TV Antenna POWER button to the ON position. This provides +12 volt power to the TV antenna amplifier located inside the antenna housing. To view the TV antenna signal on the main TV, simply press the TV ANT button located above the area marked “MAIN TV.
PAGE 4
TROUBLESHOOTING If the unit doesn’t switch properly between inputs, ( TVs, VCR, SAT, CABLE, etc.), be sure the coax is connected to the proper jacks on the back of the control box. Make sure the center conductors of the coax cables are not bent and are making good contact. See “Installing Coax Connectors” below. If you are using the +12 VDC and light does not turn ON when pushing the power button, go through the following steps. 1. 2. 3.