Instruction manual
24
/ : Single-or multiple-screen, switch to the previous/next picture display.
: Switch the screen split screen mode.
: Alarms are triggered, cancel the warning.
Channel Status:The channel is a remote monitoring, shown in green; the corresponding channel video, shown in
red; the corresponding channel alarms triggered, displayed as yellow and the Flash.
Section 5 PTZ Control
PTZ Setup
Enter ―Main Menu-PTZ Setup-PTZ ‖ as shown in Fig.15.
Fig. 15
PTZ Port: 2U Case D1 model and 2U Case CIF model, select a port for PTZ connection.
RS-485 parameters: Including baudrate, data bit, stop bit, parity bit, flow control, etc. These parameters
must be the same as those of PTZ Protocol.
PTZ Addr: Each PTZ has one different address.
Protocol: DVR had the following PTZ protocol: PELCO-D、PELCO-P2、PELCO-P1、W110、P3、PLD、
ENKEL、YAAN、SONY、JC4116、PD-NW、PD-CONST、PIH-1016、KRE301、PELCO9760、LILIN、
T3609HD、HD600、KTD、SAMSUNG、ELEC、PANASONIC、FASTRAX、DL-0001.
Speed: PTZ turning speed.
Rotate: When you set the PTZ is continuous send command.
Vertical: Reverse PTZ‘s vertical field.
Horization: Reverse PTZ‘s horizontal field.