Operation Manual

12
Accessories Installation
Wear the Hear Rate Sensor
•
Install the battery (CR2032) on the heart rate sensor.
1.
Use a coin to twist the battery cover and lock it back into the place.
2.
Insert the HR strap hook into the two sides of holes, and press it until it
3.
fixed on the rubber.
Adjust the Heart Rate straps to the most appropriate length and fit to
4.
the chest size
Place the heart rate sensor near the area of the heart on the skin, and
5.
keep the “Wintec” logo side as the front side when wearing on the
chest
Attention
To avoid measurement errors, it is recommended to
1.
moisten the electrode pads with water.
If there is any discomfort or allergy occurred, please
2.
remove it immediately .
If the sensor cannot be detected, please repairing
3.
the unit again.
For the cleanness of the heart rate monitor, you can
4.
clean it with towel in wet.