Operation Manual

14
Mount the speed, cadence
•
sensor, and magnet on the bike
Please pair the sensor before
1.
mounting it on the bike
Secure the magnet and sensors
2.
correctly on the cadence and
wheel as picture indication.
Place the magnet and faced the
3.
cadence or wheel sensor to the
magnet by the “Wintec” logo
side
Slide the straps into the sensors
4.
and fix it on the bike
wheel speed sensor
cadence sensor
the magent on
the cadence
the magnet on the
frame of rear wheel
wheel speed sensor cadence sensor
If WSG-2000 cannot connect to sensors successfully, there may be possible improper
1.
installation as the following situation：
a. The battery is not properly installed
b. The distance is too far between wheel sensor and magnet to be connected
c. The distance is too far between cadence sensor and magnet to be connected
d. The sensors have not been paired with the WSG-2000 in advance.
Generally the wheel sensor is located on the chainstay near the magnet, please note
2.
that it might be difficult to install and be connected if you install it on the front
because the different structures of types of bikes.
Attention
Please place the magnet face toward the white line on left side of cadence sensor or
speed sensor in order to make sure the correct value. Please do not face it to the central
area of the sensor.
★
Installing on Speed/Cadence