User manual

9
From Status Display push SEL and EXIT together to
enter on the Main menu
Use UP/DOWN to navigate on all available menus
Push SEL to select a menu item
Use UP/DOWN to move on the different parameters of
the menu
Push SEL to modify the parameter menu
Use UP/DOWN to change the parameter value
Keep push SEL to save changing
Push EXIT to return on the Main Menu
Push EXIT to return on the Status display
Audio settings
The Audio settings menu allows to configure the audio output.
PARAMETER
SETTING
MEANING
Lock volume
Yes/No
If set to Yes, during the “max brightness” of the display
an open lock is displayed on the Status Display. After the
“Display -Low timeout” the lock becomes closed and the
lock volume is enabled. To enable the volume setting it
is necessary turn the volume knob below the previous
setting or make a “quick turn off – turn on”.
Out mode
Mix
The left-right signals are mixed and are available as a
mono signal in both headphone channels.
The Mix mode setting serves to adjust the relative levels
of the two separate channels in the mixer mono signal.
Stereo
The left and right signals are available as usual. The
Balance setting serves to adjust the balance between
the left and right stereo signal.
Mono
The left-right signals are mixed and are available as a
mono signal in both headphone channels. It is not
possible to adjust the level of the 2 channels as in Out
mode Mix.
Balance
When Out
mode set to
Stereo
This menu allows to adjust the balance
between the left and right stereo signal
in 35 steps.
Push UP/DOWN button to change the
balance.
Mix Mode
When Out
mode set to
Mix
This menu allows to adjust the relative levels of the two
separate channels in the mixer mono signal in 35 steps.
Push UP/DOWN button to change the level.