User manual

12
Clone
The Clone menu allows to configure the quick menu and to manage the Clone setting.
PARAMETER
SETTING
MEANING
Arrow mode
Bal/Mix or
Clone
The quick menu is displayed pushing UP or DOWN
buttons when the receiver is on the Status display.
Set to Bal/Mix to enter quickly to the Balance/Mix mode
menu (according to the Out mode configured).
Set to Clone to enter quickly on the clone management.
Add
Clone
management
To add a clone
Load
To load a clone
Delete
To delete a clone
Delete all
To delete all the clones
A clone is a partial configuration of the MPR30-IEM which can be copied from a receiver to
another using the IRDA interface. It consists of the same parameters of pre-set configuration
for less than display, quick menu and headphones parameters (see the Operating menu for
more details).
From firmware version v1.3 the MPR30-IEM is able to manage up to 24 clones (from 00 to 23).
The menus of the clone management allow to add/load and delete a clone.
How to add a clone
Out mode
Balance
Equalizer
Vol boost
Pilot tone
Gr-Ch
Squelch
RX Name
Clone name
Enable the IRDA interface on the RX from
which take the configuration (Infrared menu)
Enter in the Add menu and select the
wanted clone number. Then push SEL
to start the IRDA communication.
Put the receivers face
to face
At the end of the process the name
of the clone will be identify with the
name of the receiver.