User manual

How to load a clone

Use Clone>Load menu or UP/DOWN button (if the quick menu is configured to clone) to load a

clone. Afterwards push the arrows to change clone, SEL to activeted the clone and EXIT to exit

without changing.

Ex.

The configuration saved before the loading of the clone is saved

on the clone named “default”, therefore loading the default

“clone” allows to return with the previous settings. The following

arrows displayed near the clone number indicates the

currently clone loaded.

Loading a clone, all the clone parameters are set on the receiver. The follow icon appears on

the right of the display indicating that a clone is loaded. The number and the name of the clone

are displayed on the top of the display menu and a brief list of the main parameters are

displayed on the status menu.

NOTE: the clones are saved on the EPROM and remains saved also after a reboot of the device.

NOTE: If a clone is loaded and then a reboot is executed, the MPR30-IEM always restarts with

the previous configuration (default clone).

NOTE: The symbol instead of indicates that it was modified at least one parameter of a

clone previously loaded.

NOTE: When a clone with Power limit set to OFF is loaded on the receiver but the receiver isn’t

using Lithium battery, the power limit is set automatically to the max value permitted for no

lithium battery (that is 100mW).

Name of the clone

symbol to indicate that a

clone is loaded

is loaded

Number of the clone

Main parameters